b. base cover
c. hard drive assembly
d. keyboard
e. palmrest
f. display cable
3. To remove the power connector port:
a. Disconnect the power connector port cable from the connector on the system board [1].
b. Release the power connector port cable from the placeholders.
c. Remove the screw that secures that power connector port to the computer [2].
d. Lift and remove the power connector port from the computer [3].
Installing the power connector port
1. Insert the power connector port into the slot on the computer.
2. Route the power connector port cable through the routing channels.
3. Connect the power connector port cable to the connector on the system board.
4. Tighten the screw to secure the power connector port to the computer.
5. Install the:
a. display cable
b. palmrest
c. keyboard
d. hard drive assembly
e. base cover
f. battery
6. Follow the procedure in After Working Inside Your computer.
Removing the system board
1. Follow the procedure in Before Working Inside Your Computer.
2. Remove the:
a. battery
b. base cover
c. hard drive assembly
d. WLAN card
21
To Next Page
Loading...
