3. Loosen the captive screws that secure the access panel and remove it from the computer.
Installing the Access Panel
1. Slide the access panel into its slot.
2. Tighten the screws to secure the access panel to the computer.
3. Install the battery.
4. Follow the procedures in
After Working Inside Your Computer
.
Removing the Memory Module
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove:
a) battery
b) SD card
c) access panel
3. Pry the securing clips away from the memory module until it pops up. Remove the memory module from its socket
on the system board.
12
To Next Page
Loading...
