5. Disconnect the keyboard cable from the connector on the system board and lift the keyboard off the palmrest.
Installing the Keyboard
1. Connect the keyboard cable to the connector on the system board.
2. Slide the keyboard in its place on the computer and snap it into place.
3. Install the battery.
4. Follow the procedures in
After Working Inside Your Computer
.
Removing the WLAN Card
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove:
a) battery
b) keyboard
3. Disconnect the antenna cables, remove the screw that secures the WLAN card to the system board and lift the
WLAN card from the computer.
Installing the WLAN Card
1. Insert the WLAN card in its connector at a 45–degree angle in its slot.
2. Connect the antenna cables to their respective connectors marked on the WLAN card.
3. Tighten the screw to secure the WLAN card to the computer.
17
To Next Page
Loading...
