3. Disconnect the I/O cable from the system board. Remove the screw that secures the I/O board to the computer and
lift the I/O board from the computer.
Installing the Input/Output (I/O) Board
1. Place the I/O board in its slot.
2. Tighten the screw to secure the I/O board to the computer.
3. Connect the I/O cable to the system board.
4. Install:
a) palmrest
b) keyboard
c) access panel
d) battery
5. Follow the procedures in
After Working Inside Your Computer
.
Removing the System Board
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove:
a) SD card
b) battery
c) access panel
d) memory module
e) hard drive
f) optical drive
g) keyboard
h) palmrest
i) WLAN card
21
To Next Page
Loading...
