Dell Latitude 3540 - Removing the Power Connector; Installing the Power Connector

Removing the Power Connector
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove:
a) battery
b) access panel
c) hard drive
d) optical drive
e) keyboard
f) palmrest
g) WLAN card
h) display assembly
3. Perform the following steps as shown in the illustration:
a) Disconnect the power-connector cable and release the power-connector cable from the routing channel.
b) Remove the power connector from the computer.
Installing the Power Connector
1. Align the power connector to its position in the computer.
2. Route the power-connector cable through the routing channel.
3. Connect the power-connector cable to the system board.
4. Install:
a) display assembly
b) WLAN card
c) palmrest
d) keyboard
e) optical board
f) hard drive
g) access panel
h) battery
32