4. Slide the hard drive to release it from its connector. Lift the tab to remove the hard drive from the computer.
5. Remove the screws that secure the hard-drive bracket. Lift the latch to remove the hard-drive bracket from the
hard drive.
Installing the Hard Drive
1. Place the hard drive in the hard-drive bracket and secure the latch.
2. Tighten the screws to secure the hard-drive bracket to the hard drive.
3. Slide the hard drive in its slot in the computer.
4. Tighten the screws to secure the hard drive to the computer.
5. Install:
a) access panel
b) SD card
c) battery
6. Follow the procedures in
After Working Inside Your Computer
.
14
To Next Page
Loading...
