3. To remove the memory module:
a. Pry apart the memory module latches [1].
b. Lift and remove the memory module from the system board [2].
Installing the memory module
Steps
1. Insert the memory module into its connector on the system board.
2. Gently push the memory module until the latches snap it into place.
3. Install the:
a. battery
b. base cover
4. Follow the procedure in After working inside your computer.
Hard disk drive (HDD)
Removing the hard disk drive (HDD)
Steps
1. Follow the procedure in Before working inside your computer.
2. Remove the:
a. base cover
b. battery
3. To remove the HDD:
a. Disconnect the HDD cable from the system board [1].
20
Removing and installing components
To Next Page
Loading...
