Option Description
● RAID On — default
Drives Allows you to configure the SATA drives on board.
● SATA-0 enabled by default
● eMMC (System Default)
SMART
Reporting
Controls whether hard drive errors for integrated drivers are reported during system startup.
● Disabled — default
USB
Configuration
This is an optional feature.
This field configures the integrated USB controller. If Boot Support is enabled, the system is allowed to
boot any type of USB Mass Storage Devices—HDD, memory key, floppy.
If USB port is enabled, device attached to this port is enabled and available for OS.
If USB port is disabled, the OS cannot see any device attached to this port.
The options are:
● Enable Boot Support—enabled by default
● Enable External USB Port—enabled by default
NOTE: USB keyboard and mouse always work in the BIOS setup irrespective of these settings.
USB PowerShare This field configures the USB PowerShare feature behavior. This option allows you to charge external
devices using the stored system battery power through the USB PowerShare port. This option is disabled
by default.
Audio This field enables or disables the integrated audio controller. By default, the Enable Audio option is
selected. The options are:
● Enable Microphone—by default enable
● Enable Internal Speaker—(default enable)
Touchscreen Controls whether the touchscreen is enabled or disabled.
● Enabled — default
Unobtrusive
Mode
When enabled, pressing Fn+F7 will turn off all light and sound emissions from the system.
● Disabled — default
Miscellaneous
Devices
Allows you to enable or disable the following devices:
● Camera (default enable)
● Secure Digital (SD) card—enabled
● Secure Digital (SD) card read-only-mode
● Hard drive Free Fall Protection — enabled
● Secure Digital (SD) Boot — enabled
Video screen options
Option
Description
LCD Brightness Allows you to set the display brightness depending up on the power source—On Battery and On AC. The
LCD brightness is independent for battery and AC adapter. It can be set using the slider.
Security screen options
Option
Description
Admin Password Allows you to set, change, or delete the administrator (admin) password.
NOTE: You must set the admin password before you set the system or hard drive password. Deleting
the admin password automatically deletes the system password and the hard drive password.
System setup options 43