Option Description
NOTE: Successful password changes take effect immediately.
Default setting: Not set
System
Password
Allows you to set, change, or delete the system password.
NOTE: Successful password changes take effect immediately.
Default setting: Not set
Internal HDD-0
Password
Allows you to set, change, or delete the administrator password.
NOTE: Successful password changes take effect immediately.
Default setting: Not set
Strong Password Allows you to enforce the option to always set strong passwords.
Default Setting: Enable Strong Password is not selected.
NOTE: If Strong Password is enabled, the Admin and System passwords must contain at least one
uppercase character, one lowercase character and be at least eight characters long.
Password
Configuration
Allows you to specify the minimum and max password lengths of the Administrator and System
passwords.
● min-4—by default, if you want to change you can increase the number.
● max-32—you can decrease the number.
Password Bypass Allows you to enable or disable the permission to bypass the System and the Internal HDD password,
when they are set. The options are:
● Disabled —enabled by default
● Reboot bypass
Password
Change
Allows you to enable the disable permission to the System and Hard Drive passwords when the admin
password is set.
Default setting: Allow Non-Admin Password Changes is selected.
Non-Admin Setup
Changes
Allows you to determine whether changes to the setup options are allowed when an Administrator
Password is set. If disabled, the setup options are locked by the admin password.
Option "allow wireless switch changes" is not selected by default.
UEFI Capsule
Firmware
Updates
Allows you to enable or disable. This option controls whether this system allows BIOS updated via UEFI
capsule update packages. The options are:
● Enable UEFI Capsule Firmware—enabled by default
TPM 2.0 Security Allows you to enable the Trusted Platform Module (TPM) during POST. The options are:
● TPM On—enabled by default
● Clear
● PPI Bypass for Enable Commands—enabled by default
● PPI Bypass for Disabled Commands
● Attestation enable—enabled by default
● Key storage enable—enabled by default
● SHA-256—enabled by default
● Disabled
● Enabled—enabled by default
NOTE: To upgrade or downgrade TPM 2.0, download the TPM wrapper tool—software.
Computrace Allows you to activate or disable the optional Computrace software The options are:
● Deactivate
● Disable
● Activate—enabled by default
44 System setup options
To Next Page
Loading...
