Verifying system memory
Windows 10
1. Tap the Windows button and select All Settings
> System .
2. Under System, tap About.
Verifying system memory in system setup (BIOS)
Steps
1. Turn on or restart your system.
2. Perform the following actions after the Dell logo is displayed
● With keyboard — Tap F2 until the Entering BIOS setup message appears. To enter the Boot selection menu, tap F12.
3. On the left pane, select Settings > General > System Information,
The memory information is displayed on the right pane.
Testing memory using ePSA
Steps
1. Turn on or restart your system.
2. Perform one of the following actions after the Dell logo is displayed:
● With keyboard — Press F12.
The PreBoot System Assessment (PSA) starts on your system.
NOTE:
If you wait too long and the operating system logo appears, continue to wait until you see the desktop. Turn off
the laptop and try again.
Hard drive options
This laptop supports :
● 128GB M.2 2280 SSD (via carrier)
● 256GB M.2 2280 SSD (via carrier)
● 64GB M.2 2242 SSD (via carrier)
● 2.5" 500GB 7200 RPM HDD (7mm)
● 2.5" 1TB 5400 RPM HDD (7mm)
● 2.5" 500GB Hybrid 8GB (7mm)
● 32GB M.2 2242 SSD (in WWAN slot)
● Dell Fast Response Free Fall Sensor and HDD Isolation (standard feature)
Identifying the hard drive in Windows 10
Steps
1. Click All Settings
on the Windows 10 Charms Bar.
2. Click Control Panel, select Device Manager, and expand Disk drives.
The hard drive is listed under Disk drives.
Technology and components
35
To Next Page
Loading...
