Installing the base cover
1 Align the base cover tabs to the slots on the edges of the computer.
2 Press the edges of the cover until it clicks into place.
3 Tighten the M2.5 x 5.0 captive screws to secure the base cover to the computer.
4 Follow the procedure in After working inside your computer.
Battery
Removing the battery
1 Follow the procedure in Before working inside your computer.
2 Remove:
a MicroSD card
b Base cover
3 To remove the battery:
a Lift the ribbon, and disconnect the battery cable from the connector on the system board [1].
b Remove the M2.0 x 4 L screws that secure the battery to the computer [2].
NOTE
: The image displayed is for reference only. Some components location and screw may vary.
c Lift the battery from the computer [3].
Removing and installing components
11
To Next Page
Loading...
