b Remove the M2.0 x 3.0 screws that secure the fan to the system board[2].
c Remove the M2.0 x 3.0 screws that secure the heat sink to the system board [3].
d Lift the heat sink assembly from the system board.
Installing heat sink assembly
1 Align the heat sink assembly with screw holders on the system board.
2 Replace the M2.0 x 3.0 screws to secure the heat sink to the system board.
NOTE
: Tighten the screws on the system board in the order of the callout numbers [1, 2, 3, 4] as indicated on the heat
sink.
3 Replace the M2.0 x 3.0 screws to secure the fan to the system board.
4 Connect the fan cable to the connector on the system board.
5 Install the:
a battery
b base cover
6 Follow the procedure in After working inside your computer.
Display Assembly
Removing the display assembly
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a Micro SD
b base cover
Removing and installing components
23
To Next Page
Loading...
