NOTE: You can use a plastic scribe to lift the speaker module from the computer.
Installing the speaker module
1 Place the speaker module into the slots on the computer.
2 Route the speaker cable through the routing channel and secure it with the tapes.
3 Connect the speaker cable to the connector on the system board.
4 Connect the LED cable to the connector on the palm rest.
5 Install the:
a power board
b battery
c base cover
d Micro SD
6 Follow the procedure in After working inside your computer.
Fingerprint Board
Removing the ngerprint reader board
1 Follow the procedure in Before working inside your computer.
2 Remove:
a Micro SD
b base cover
c battery
3 To remove the ngerprint reader board:
a Lift the coin cell battery axed to the speaker cables [1].
18
Removing and installing components
To Next Page
Loading...
