Finger Print
Bracket
1
Touch pad 2
Smart Card 2
K/B to K/B
plate
6 1
K/B plate 13
Bottom Door
Assy
8
System board 6
Fan 1 1
Thermal 4
Battery 4
WLAN 1
WWAN 1
MSATA 1
EDP Bracket 2
USB Type C 2
MB
Recommended tools
The procedures in this document require the following tools:
• Phillips #0 screwdriver
• Phillips #1 screwdriver
• Plastic scribe
NOTE
: The #0 screw driver is for screws 0-1 and the #1 screw driver is for screws 2-4
Micro Secure Digital (SD) Card
Removing the Micro Secure Digital (SD) Card
1 Follow the procedure in Before working inside your computer.
2 Press in on the Micro SD card to release it from the computer.
3 Slide the Micro SD card out of the computer.
Installing the Micro Secure Digital (SD) Card
1 Slide the Micro SD into the slot until it clicks into place.
2 Follow the procedures in After working inside your computer.
Subscriber Identity Module (SIM) Card
Removing and installing components
9