Installing the power board
1 Insert the power board into the slot.
2 Replace the M2.0x3.0 screws to secure the power board to the computer.
3 Connect the power board cable to the connector on the system board.
4 Ax the coin cell battery in the slot on the computer.
5 Install the:
a battery
b base cover
c MicroSD card
6 Follow the procedure in After working inside your computer.
Speaker
Removing the speaker module
1 Follow the procedure in Before working inside your computer.
2 Remove:
a MicroSD card
b base cover
c battery
d power board
3 To disconnect the cables:
a Disconnect the and fold back the smart card cable [1].
b Disconnect and fold back the LED board for easy access in removing the speaker module [2].
16
Removing and installing components
To Next Page
Loading...
