Installing the NVMe SSD
1 Insert the NVMe SSD card into the connector.
2 Install the thermal bracket over the SSD card.
3 Tighten the M2.0 x 3.0 screws to secure the SSD thermal bracket.
4 Install the:
a battery
NOTE
: If you have not removed the battery, you must connect the battery cable to the system board.
b base cover
c MicroSD card
5 Follow the procedure in After working inside your computer.
WLAN card
Removing the WLAN card
1 Follow the procedure in Before working inside your computer.
2 Remove:
a MicroSD card
b base cover
c battery
NOTE
: You need not remove battery, instead you can disconnect the battery cable from the system board.
3 To remove the WLAN card:
a Remove the M2.0 x 3.0 screw that secures the metal bracket to the WLAN card [1].
b Lift the metal bracket [2].
Removing and installing components
13
To Next Page
Loading...
