Dell Latitude 7400 2-in-1 - Heatsink; Removing the Heatsink

Next steps
1. Connect the battery cable
2. Install the base cover.
3. Install the SD memory card.
4. Follow the procedure in after working inside your computer.
Heatsink
Removing the heatsink
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the SD memory card.
3. Remove the base cover.
4. Disconnect the battery cable.
Steps
1. Partially peel off the Mylar sheet [1] from the system board.
2. Disconnect the camera and touch screen FPC cable [2] from the connector on the system board.
3. Peel off the camera and touch screen FPC cable from the heatsink shield [3].
Removing and installing components
55