Dell Latitude 7400 2-in-1 - Installing the Display Assembly

NOTE: The display assembly for the Latitude 7400 2-in-1 is a Hinge-Up Design (HUD) assembly and cannot be further
disassembled once it is removed from the bottom chassis. If any components of the HUD assembly are malfunctioning
and need to be replaced, replace the entire display assembly.
Installing the display assembly
Steps
1. Install the display assembly with hinges open at 180º aligned to the computer [1].
2. Replace the six (M2.5x3.5) screws [1] that secures the display hinges to the computer [2].
3. Connect the display cable [1] to the connector on the system board.
4. Close the latch [2] and adhere the tape on the display cable [3].
66
Removing and installing components