8. Remove the single (M2x2) screw [1] securing the power fingerprint bracket to system board.
9. Remove the power fingerprint bracket [2] and disconnect the cable from the system board [3].
10. Disconnect the LTE P-sensor and isolator antenna cables [4] from the system board.
11. Disconnect the LTE MAIN and AUX antennae cables [5] from the system board.
Insert a plastic scribe into the slit at the bottom-left corner of the connector and then carefully pry up the cable connector
from the system board.
Removing and installing components
75
To Next Page
Loading...
