Dell Latitude 9440 2-in-1 - Solid-State Drive

Steps
1. Connect the battery cable to the connector on the system board.
2. Align and place the base cover on the palm-rest assembly, and snap the base cover into place.
3. Tighten the six captive screws to secure the base cover to the system.
Next steps
1. Install the SIM card tray.
2. Follow the procedure in After working inside your computer.
Solid-state drive
Removing the solid-state drive
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your
computer.
2. Remove the base cover.
Removing and installing components
15