Steps
1. Align and place the left fan onto the palm-rest assembly.
2. Replace the two (M1.6x3) screws to secure the left fan to the palm-rest assembly.
3. Connect the left fan cable to the connector on the system board.
4. Adhere the mylar sticker on the left fan FPC connector.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Display assembly
Removing the display assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE:
Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your
computer.
2. Remove the base cover.
About this task
The following images indicate the location of the display assembly and provide a visual representation of the removal procedure.
Removing and installing components
23
To Next Page
Loading...
