Steps
1. Peel off the mylar sticker from the left fan FPC connector.
2. Disconnect the left fan FPC cable from the connector on the system board.
3. Remove the two (M1.6x3) screws that secure the left fan to the palm-rest assembly.
4. Lift the left fan off the palm-rest assembly.
Installing the left fan
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the left fan and provides a visual representation of the installation procedure.
22
Removing and installing components
To Next Page
Loading...
