Installing the palm-rest and keyboard assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the palm-rest and keyboard assembly and provide a visual representation of the
removal procedure.
Steps
Place the palm-rest and keyboard assembly on a flat surface.
Next steps
1. Install the power button.
2. Install the left speaker.
3. Install the right speaker.
4. Install the system board.
5. Install the battery.
6. Install the heat sink.
7. Install the display assembly.
8. Install the left fan.
9. Install the right fan.
10. Install the WWAN card if applicable.
11. Install the solid-state drive.
12. Install the base cover.
13. Install the SIM card tray if applicable.
14. Follow the procedure in After working inside your computer.
52
Removing and installing components
To Next Page
Loading...
