11. Follow the procedure in After working inside your computer.
Palm-rest and keyboard assembly
Removing the palm-rest and keyboard assembly
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE: Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your
computer.
2. Remove the SIM card tray if applicable.
3. Remove the base cover.
4. Remove the solid-state drive.
5. Remove the WWAN card if applicable.
6. Remove the right fan.
7. Remove the left fan.
8. Remove the display assembly.
9. Remove the heat sink.
10. Remove the battery.
11. Remove the system board.
12. Remove the right speaker.
13. Remove the left speaker.
14. Remove the power button.
About this task
The following images indicate the location of the palm-rest and keyboard assembly and provide a visual representation of the
removal procedure.
Removing and installing components
51
To Next Page
Loading...
