Steps
1. Peel the tape securing the left speaker cable to the chassis.
2. Disconnect the left speaker cable from connector on the system board.
3. Remove the two (M1.6x1.8) screws that secure the left speaker in place.
4. Lift the left speaker off the chassis.
Installing the left speaker
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
For systems shipped with WWAN antennas, left speaker is part of the palm-rest assembly and are not separate
replaceable parts.
NOTE: For systems shipped with WLAN card, left speaker is a separate replaceable part. The following procedure is
applicable for systems shipped with WLAN card only.
The following image indicates the location of the speaker and provides a visual representation of the installation procedure.
Removing and installing components
35
To Next Page
Loading...
