● Do not use tools of any kind to pry on or against the battery.
● Ensure any screws during the servicing of this product are not lost or misplaced, to prevent accidental
puncture or damage to the battery and other system components.
● If the battery gets stuck inside your computer as a result of swelling, do not try to release it as puncturing,
bending, or crushing a rechargeable Li-ion battery can be dangerous. In such an instance, contact Dell
technical support for assistance. See www.dell.com/contactdell.
● Always purchase genuine batteries from www.dell.com or authorized Dell partners and resellers.
● Swollen batteries should not be used and should be replaced and disposed properly. For guidelines on how to
handle and replace swollen rechargeable Li-ion batteries, see Handling swollen rechargeable Li-ion batteries.
Removing the battery
Prerequisites
1. Follow the procedure in Before working inside your computer.
NOTE: Ensure that your computer is in Service Mode. For more information see, step 6 in Before working inside your
computer.
2. Remove the base cover.
3. Remove the WWAN card.
NOTE: If battery was disconnected from system board for service, there will be a delay during system boot-up as the
system will undergo RTC battery reset.
About this task
The following images indicate the location of the battery and provide a visual representation of the removal procedure.
Removing and installing components
29
To Next Page
Loading...
