Recommended tools
The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Plastic scribe
Screw list
NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Screw type Quantity Image
Base cover Captive screws 6
Solid-state drive M1.2x1.5 1
WWAN card Captive screw 1
Right fan M1.6x3 2
Left fan M1.6x3 2
Display cable/ Left Type-C
bracket
M1.6x3 2
Right Type-C bracket M1.6x3 3
Display assembly M2.5x4 6
Heat sink Captive screws 3
Battery
M2x3 6
Right speaker M1.6x1.8 2
Left speaker M1.6x1.8 2
Removing and installing components 53
To Next Page
Loading...
