Dell Latitude 9440 2-in-1 - Page 38

Steps
1. Align and place the right speaker into the slot on the chassis.
2. Replace the two (M1.6x1.8) screws to secure the right speaker to the system.
3. Adhere the tape to secure the right speaker to the chassis.
4. Connect the right speaker cable to connector on the system board.
5. Adhere the tape to secure the right speaker cable to the chassis.
When installing the left and right speakers, secure the speaker cables in place with pieces of tape adhered to the palm rest.
Next steps
1. Install the battery.
2. Install the WWAN card if applicable.
3. Install the base cover.
38
Removing and installing components