Table 6. System setup optionsāStorage menu
Storage
SATA/NVMe Operation
SATA/NVMe Operation Set the operating mode of the integrated storage device controller. By default,
the RAID On option is enabled.
Storage Interface
Port Enablement
By default, the M.2 PCIe SSD-0 option is enabled.
SMART Reporting
Enable SMART Reporting Enable or disable Self-Monitoring, Analysis, and Reporting Technology
(SMART) during computer startup.
By default, the Enable SMART Reporting option is not enabled.
Drive Information
Table 7. System setup optionsāDisplay menu
Display
Display Brightness
Brightness on battery power Enable to set screen brightness when the computer is running on battery
power.
Brightness on AC power Enable to set screen brightness when the computer is running on AC power.
Touchscreen
By default, the option is enabled.
Full Screen Logo Enable or disable full screen logo.
By default, the option is not enabled.
Table 8. System setup optionsāConnection menu
Connection
Wireless Device Enable
WWAN/GPS Enable or disable the internal WWAN/GPS device
By default, the option enabled.
WLAN Enable or disable the internal WLAN device
By default, the option enabled.
Bluetooth Enable or disable the internal Bluetooth device
By default, the option enabled.
Enable UEFI Network Stack Enable or disable UEFI Network Stack and controls the on-board LAN
Controller.
By default, the Enable UEFI Network Stack option are enabled.
Wireless Radio Control
Control WLAN radio Sense the connection of the computer to a wired network and subsequently
disable the selected wireless radios (WLAN).
By default, the option is disabled.
Control WWAN radio Sense the connection of the computer to a wired network and subsequently
disable the selected wireless radios (WWAN).
By default, the option is disabled.
Dynamic Wireless Transmit Power
By default, the option is enabled.
BIOS setup 61
To Next Page
Loading...
