5. Remove the Base cover.
About this task
The following images indicate the location of the speaker and provide a visual representation of the removal procedure.
Steps
1. Peel off the adhesive tape that secures the battery cable to the system board.
2. Disconnect the speaker cable, and unroute the speaker cable from the routing guide.
3. Remove the four (M1.6x1.8) screws that secure the speakers, and remove the speakers from the system.
Installing the speaker
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speaker and provides a visual representation of the installation procedure.
Removing and Installing Components
25
To Next Page
Loading...
