Steps
1. Align and place the power button assembly on the system. Adhere the power button assembly on the palm rest.
2. Install the power button bracket on the system.
3. Install the three M1.5x2.5 screws securing the fingerprint reader bracket.
Next steps
1. Install the I/O board.
2. Install the Fan.
3. Install the Base cover.
4. Install the SIM card tray.
5. Install the microSD card.
6. Follow the procedure in After working on your computer .
Power button with finger print reader (optional)
Removing the power button with fingerprint reader
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the microSD card.
3. Remove the SIM card tray.
4. Enter service mode.
5. Remove the Base cover.
6. Remove the system fan.
7. Remove the I/O board .
About this task
The following images indicate the location of the fingerprint reader and provide a visual representation of the removal
procedure.
34
Removing and Installing Components
To Next Page
Loading...
