Installing the keyboard
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the keyboard and provides a visual representation of the installation procedure.
Steps
1. Align and place the keyboard on the palmrest.
2. Install the four M1.6x2 and thirty-six M1.6x1.5 screws to secure the keyboard.
3. Connect the keyboard cable and backlight cable to the connectors on the touchpad.
4. Adhere the antenna cable, WWAN Darwin cable, touchpad FPC, LED FFC to the keyboard.
Next steps
1. Install the System board
2. Install the I/O board.
54
Removing and Installing Components
To Next Page
Loading...
