Dell Latitude D430 - Internal Card with Bluetooth Wireless Technology

Back to Contents Page
 Internal Card With Bluetooth®Wireless Technology
Dell™Latitude™D430
If you ordered an internal card with Bluetooth wireless technology with your computer, it is already installed.

1. Follow the procedures in "BeforeYouBegin"onpage7.

2. Remove the hinge cover (see Hinge Cover).

3. Remove the keyboard (see Keyboard).

4. Remove the M2 x 3-mm screw from the card holder and lay the holder aside.

5. Lift the card away from the aligning pin.

6. Disconnect the card cable connector from the card.
Back to Contents Page

CAUTION: Before performing the following procedures, read the safety instructions in your Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of
the computer.
NOTICE: To prevent damage to the system board, remove the main battery before you service the computer.
1
internal card with Bluetooth wireless
technology
2
card cable
connector
3
M2 x 3-mm
screw
4
card holder
5
aligning pin


NOTICE: Be careful when removing the card to avoid damaging the card, card cable, or surrounding components.