7. Remove the screws that secure the display assembly in place.
8. Remove the display assembly from the computer.
Installing the Display Assembly
1. Install the screws that secure the display assembly in place.
2. Insert the low-voltage differential signaling (LVDS) cable and wireless antenna cables through the
holes on the chassis.
3. Route the LVDS cable along its compartment and connect the connector to the system board.
4. Connect the antenna cables to their connectors.
5. Install :
a) palmrest
b) right access panel
c) optical drive
d) keyboard
e) keyboard trim
f) access panel
g) battery
h) SD memory card
6. Follow the procedures in After Working Inside Your Computer.
40
To Next Page
Loading...
