7. Release the system board from the port connectors on the left and remove the system board.
Installing the System Board
1. Align the system board into its original position on the computer.
2. Replace and tighten the screws to secure the system board to the computer.
3. Route and connect the following cables the system board:
a) audio board flat flex cable
b) Bluetooth cable
c) speaker cable
d) DC-in cable
e) thermal fan cable
4. Install :
a) left support frame
b) display assembly
c) ExpressCard reader cage
d) palm rest
e) thermal module
f) right base panel
g) hard drive
h) optical drive
i) keyboard
j) keyboard trim
k) access panel
l) battery
m) SD memory card
5. Follow the procedures in After Working Inside Your Computer.
47
To Next Page
Loading...
