Connecting the S5000 to the Network
After you have completed the hardware installation and software configuration for the
S5000 system, you can connect to your company network by following your company’s
cabling requirements.
Figure 25. RJ-45 Network/Management Port
Technical Specifications
NOTE: Operate the product at an ambient temperature not higher than 40°C.
CAUTION: Lithium Battery Caution: There is a danger of explosion if the battery is
incorrectly replaced.
NOTE: Replace the battery only with same or equivalent type. Dispose of the
batteries according to the manufacturer's instructions.
Table 7. Chassis Physical Design
Parameter Specifications
Height 1.71 inches (43.5 mm)
Width 17.4 inches (441 mm)
Depth 28 inches (711 mm)
Chassis weight with factory-installed
components
34 pounds (approx.) (15.42 kg)
Rack clearance required
• Front: 5 inches (12.7 cm)
45
To Next Page
Loading...
Need help?
General