Dell Networking S6000 - Configuring a Two-Post Center-Mount

Install the S6000 | 25
Configuring a Two-Post Center-Mount
Step Task
1 Slide the plunger bracket rearward until it clicks into place and secure the bracket to the front post flange with two
user-supplied screws. Refer to Figure 4-3 , item 1.
Figure 4-3. Two-Post Center-Mount Configuration
2 Slide the back bracket towards the post and secure it to the post flange with two user-supplied screws. Refer to
Figure 4-3 , item 2.
3 Repeat this procedure for the second rail.