Dell NOT22366 - Display Cable; Removing the Display Cable

About this task
NOTE: This procedure applies only to computers with a plastic chassis.
The following images indicate the location of the camera module and provide a visual representation of the installation
procedure.
Steps
1. Using the alignment post, adhere the camera module on the display back-cover and antenna assembly.
2. Connect the display cable to the connector on the camera module.
Next steps
1. Install the display panel.
2. Install the display hinges.
3. Install the display bezel.
4. Install the display hinge caps.
5. Install the display assembly.
6. Install the wireless card.
7. Install the base cover.
8. Follow the procedure in After working inside your computer.
Display cable
Removing the display cable
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the wireless card.
4. Remove the display assembly.
5. Remove the display hinge caps.
6. Remove the display bezel.
7. Remove the display hinges.
102
Removing and installing Field Replaceable Units (FRUs)
103 / 136 102 / 134 103 / 136