Dell NOT22366 - Camera; Removing the Camera; Installing the Camera

Camera
Removing the camera
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the wireless card.
4. Remove the display assembly.
5. Remove the display hinge caps.
6. Remove the display bezel.
7. Remove the display hinges.
8. Remove the display panel.
About this task
NOTE: This procedure applies only to computers with a plastic chassis.
The following images indicate the location of the camera module and provide a visual representation of the removal procedure.
Steps
1. Disconnect the display cable from the connector on the camera module.
2. Using a plastic scribe, gently pry the camera off the display back-cover and antenna assembly.
3. Remove the camera module from the display assembly.
Installing the camera
CAUTION: The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
Removing and installing Field Replaceable Units (FRUs)
101
102 / 136 101 / 134 102 / 136