Dell OptiPlex 160 - I;O Board; Removing the I;O Board; Replacing the I;O Board

Back to Contents Page
 I/O Board
Dell™OptiPlex™FX160/160ServiceManual
Removing the I/O Board
Replacing the I/O Board
Removing the I/O Board

1. Perform the procedure in Before Working on Your Computer.

2. Remove the two screws that secure the I/O board to the chassis.

3. Carefully lift the I/O board out of the computer, ensuring the three cables are clear of the cable guide.

4. Disconnect the three cables (Audio, USB and Front Panel) from the I/O board.
Replacing the I/O Board

1. Connect the three I/O board cables (Audio, USB, and Front Panel) to the I/O board.

2. Place the cables under the cable guide metal tab, and align the holes in the I/O board with the screw holes on the chassis, ensuring that the middle of
the I/O board rests in the metal clip.

3. Secure the I/O board to the chassis with two screws.
1
screws (2)
2
cable guide
1
front panel connector
2
audio connector
3
USB connector
4
I/O board