4. Remove the screws that secure the bracket to the optical disk drive and remove it from the optical drive.
Installing the Optical Disk Drive
1. Place the bracket on the optical disk drive and tighten the screws to secure it.
2. Slide the optical disk drive to the computer and tighten the screw to secure it.
3. Connect the cables to the control board.
4. Install:
a) back cover
b) VESA stand
c) stand cover
5. Follow the procedures in
After Working Inside Your Computer
.
Removing the Control Board
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove:
14
To Next Page
Loading...
