Dell OptiPlex 3011 AIO - Installing the Speakers; Removing the Power Switch

Installing the Speakers
1. Tighten the screws to secure the speakers to the computer.
2. Guide the speaker cables through the tabs on the computer and connect the cable to the system board.
3. Install:
a) system board cover
b) back cover
c) VESA stand
d) stand cover
4. Follow the procedures in After Working Inside Your Computer .
Removing the Power Switch
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove:
a) stand cover
b) VESA stand
c) back cover
d) system board cover
3. Disconnect the power-switch cable from the system board. Release the power-switch cable from its tabs on the
chassis.
4. Remove the screw that secures the power switch to the computer. Release and remove the power switch from the
computer.
23