Dell OptiPlex 3011 AIO - Removing the Camera; Installing the Camera

m) VESA stand
n) stand cover
5. Follow the procedures in After Working Inside Your Computer .
Removing the Camera
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove:
a) stand cover
b) VESA stand
c) back cover
d) system board cover
e) WLAN card
f) memory
g) heat sink
h) hard drive
i) optical drive
j) control board
k) system fan
l) intrusion switch
m) power switch
n) system board
o) display bracket
3. Remove the screws that secure the camera to the computer and remove it from the computer.
Installing the Camera
1. Place the camera on the computer.
2. Tighten the screws to secure the camera to the computer.
3. Install:
a) display bracket
b) system board
35