Dell OptiPlex 3011 AIO - Removing the Hard Drive

Installing the Power Switch
1. Place the power switch into its slot on the computer and tighten the screws to secure the it to the computer.
2. Guide the power-switch cable through the tabs on the computer and connect the power-switch cable to the system
board.
3. Install:
a) system board cover
b) back cover
c) VESA stand
d) stand cover
4. Follow the procedures in After Working Inside Your Computer .
Removing the Hard Drive
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove:
a) stand cover
b) VESA stand
c) back cover
3. Move the hard-drive cable to access the hard-drive bracket screws. Remove the screws and slide the hard-drive
bracket to release it from the chassis.
24