Steps
1. Align and adhere the SSD thermal pad in the mark on the system board.
NOTE: Check the adhesive direction before adhering it to the system board.
2. Align the notch on the solid-state drive module with the connector on the system board and slide the solid-state drive at an
angle into the slot.
3. Replace the (M2x3.5) screw to secure the solid-state drive module to the system board.
Next steps
1. Install the cover.
2. Install the device on Fixed stand/Pro 1 height-adjustable stand/Offset VESA mount/Pro 2 height-adjustable stand/Wall
mount.
3. Follow the procedure in after working on your device.
106
Removing and installing components
To Next Page
Loading...
