Installing the cover
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the cover and provides a visual representation of the installation procedure.
Steps
1. Align the tabs on the cover with the slots on the chassis.
2. Slide the cover until it clicks into place.
Next steps
1. Install the device on Fixed stand/Pro 1 height-adjustable stand/Offset VESA mount/Pro 2 height-adjustable stand/Wall
mount.
2. Follow the procedure in after working on your device.
Removing and installing components
99
To Next Page
Loading...
