Steps
1. Slide and insert the 3.5-inch hard-disk drive into the hard-disk drive slot.
2. Replace the fours (#6-32) screws to secure the hard-disk drive to the chassis.
3. Route the power cable and the data cable through the routing guides and connect the cables to the hard-disk drive.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Solid-state drive
Removing the M.2 2230 PCIe solid-state drive
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the fan duct.
About this task
The following images indicate the location of the solid-state drive and provide a visual representation of the removal procedure.
22
Removing and installing components
To Next Page
Loading...
