Installing The Power Switch
1. Slide the power-switch cable in through the front of the computer.
2. Secure the power-switch cable to the chassis.
3. Connect the power-switch cable to the system board.
4. Install the front bezel.
5. Install the cover.
6. Follow the procedures in
After Working Inside Your Computer
.
Removing The Input/Output Panel
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove the
a) cover
b) front bezel
c) hard drive
d) optical drive
3. Disconnect the 24–pin connector from the system board.
33
To Next Page
Loading...
