Dell OptiPlex 9010 AIO - Removing the Intrusion Switch

a) VESA mount bracket
b) back cover
c) VESA stand
6. Follow the procedures in After Working Inside Your Computer .
Removing the Intrusion Switch
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the:
a) VESA stand
b) back cover
c) VESA mount bracket
d) system-board shield
3. Disconnect the intrusion cable from the connector on the system board. Unthread the cable from the notches on
the computer.
4. Remove the screws that secure the intrusion switch to the chassis. Lift the intrusion switch and remove it from the
computer.
17