Dell OptiPlex 9010 AIO - Installing the Display Panel

Installing the Display Panel
1. Tighten the screws to secure the display bracket to the display panel.
2. Place the display panel on the chassis.
3. Place the base panel on the chassis.
4. Tighten the screws to secure the base panel to the chassis.
5. Connect the LVDS cable to the connector.
6. Install:
a) system board
b) antenna module
c) speakers
d) system board
e) processor fan
f) heat-sink assembly
g) power supply unit
h) power-supply fan
i) converter board
j) power-button board
k) intrusion switch
l) hard drive
m) optical drive
n) WLAN card
o) input/output board shield
p) system-board shield
q) VESA mount bracket
r) back cover
s) VESA stand
7. Follow the procedures in After Working Inside Your Computer .
33